Capacitor Mounting Accessories

Print Friendly, PDF & Email

 

Capacitor Mounting Accessories Brackets and Adaptors

Capacitor Mounting Accessories for GenMet Metal Electrical Enclosures E1 & E2

GenMetGenMet offers Capacitor Mounting Accessories for easy mounting solutions. Capacitor Mounting Accessories such as Capacitor Mounting Brackets make it easy to add (85mm) power factor capacitor inside of the motor control cabinet, where it is needed. This enables the power factor capacitors to be switched on/off by the motor starter and eliminates the need for capacitor fuses or an additional switch.  These “L” brackets can help you to achieve a convenient and low cost means of adding power factor capacitors to your individual motors. For use with cylindrical power factor capacitors having a single mounting stud (1/2” hole provided as standard).

Capacitor Mounting Brackets
Cat. No. # of Capacitors Length Width Height

Capacitor Mounting Accessories

Capacitor Mounting Brackets
Ideal For:
New Production
Capacitor Replacement
Power Factor Correction at the Motor
More…

BL-1 1 3.75” 3.75” 1.00”
BL-2 2 8.0” 3.75” 1.00”
BL-4 3-4 8.0” 7.75” 1.00”

 Adaptor Brackets for Replacing Rectangular Capacitors with Cylindrical Capacitors

Capacitor Adaptor Brackets (Rectangular to Round) enable you to conveniently replace the older type rectangular power factor or filter capacitors with present type cylindrical capacitors. Rectangular capacitors were typically secured by two bolts on the sides of the capacitor, whereas contemporary capacitors use single hole mounting (1/2” hole provided). Simply attach cylindrical capacitor to the adaptor bracket then bolt the bracket using existing side slots. Wire the replacement capacitor in place.

Capacitor Adaptor Bracket

Capacitor Mounting Accessories

Capacitor Mounting Accessories for Replacing Rectangular Capacitors with Cylindrical Capacitors

Capacitor Mounting Accessories

Capacitor Mounting Accessories Adaptor Brackets

Capacitor Mounting Accessories

Adaptor brackets can be overlapped

Cat. No.

BA-1

Length

5.50″

Width

3.00″

Height

.78″

 

 

 

 

Contact US or Call our office for Quotes and Application Engineering
1-262-618-2403
Visit GenMet at site: www.GenMet.com