GenMet Enclosure Get a Quote

GenMet Quote Form

  • Series E1 Enclosures Type 1 & Type 3R

    Series E1 Enclosures Type 1 (indoor) Select from above
    Series E1 Enclosures Type 3R (outdoor) Select from above
  • Series E2 Enclosures Type 1 & Type 3R

    Series E2 Enclosures Type 1 (indoor) Select from above
    Series E2 Enclosures Type 3R (outdoor) Select from above
  • Floor / Pad Mounting Kit

    The standard mounting base kit adds 6” to the enclosure height and contains two (2) foot mounting brackets plus the 1/4 inch zinc plated steel hardware for use in securing each base to the bottom of the enclosure. The installer must also properly secure the enclosure with mounting base to the concrete pad or floor. Use these kits to maintain Type 3R integrity of E2 enclosures also when using feet for mounting on surfaces outdoors.
  • Mounting Panels - Full, 1/2 & 1/4

  • Full, 1/2 and 1/4 Panels
    Mounts in vertical plane as back panel = Full Size Panel
    Mounts in vertical and horizontal plane. Use as vertical panel in top half or as horizontal bottom panel. *Indicates can be used with E2 Enclosures.
    Mounts in vertical plane near top of enclosure. Ideal for terminal blocks.
  • Capacitor Mounting Brackets

    Ideal for mounting (85mm) cylindrical capacitors having a single mounting stud (1/2” hole provided as standard).
  • Capacitor Adaptor Bracket

    Capacitor Adaptor Brackets (Rectangular to Round) enable you to conveniently replace the older type rectangular power factor or filter capacitors with present type cylindrical capacitors.
  • Thank you!

  • This field is for validation purposes and should be left unchanged.